BDX / SSI - Arctic Cat Catalyst Belt Drive Assembly
***THESE ARE PRE-ORDER ONLY AND NON-CANCELLABLE / NON-REFUNDABLE***
The ONLY aligned Belt drive assembly on the market for the CATALYST Chassis! This system Removes the eccentric Bearing on the belt drive, changes the jackshaft location and adds a tensioner pulley allowing 3 key features:
-Truly Aligned sheaves
-Easier Belt changes
-Maximize Gearing Possibilities 2.63 to 1.67 Ratios Available
LIMITED AVAILABILITY PRE-ORDER - All orders placed before JULY 1st Guaranteed Delivery by or BEFORE OCTOBER 1st!
***THESE ARE PRE-ORDER ONLY AND NON-CANCELLABLE / NON-REFUNDABLE***
Orders placed after 7/1/25 may not be delivered until as early as 2026
Fits ALL Catalyst Models
The ONLY aligned Belt drive assembly on the market for the CATALYST Chassis! This system Removes the eccentric bearing on the belt drive, changes the jackshaft location and adds a tensioner pulley allowing the ability for easier, faster belt changes, maximizing the gearing potential and most importantly aligning the secondary to the primary sheave.
We tested with and without our belt drive seeing over 30 Degree cooler sheave temps on the secondary and primary sheaves and between 40-50 Degree belt temp drops depending on the type of belt. Those readings were done in a temperature-controlled track dyno cell with the panels off; in the field, belt and sheave temps dropped an additional 10 Degrees on average over the stock setup. Better yet for the Racers and high-performance Trail Riders, in our field testing we saw the clutch shift into overdrive up to 3 seconds faster than the factory setup with a much smoother shift throughout.
Super easy install
Direct bolt on, No cutting, No drilling, No rivets
Uses the Stock 896 Drive Belt & works with stock muffler
Wide range of ratios available from 2.63-1.67, perfect for gear ups big or small to get more track speed for anything from climbing a hill to flying across the lake!
For reference, Stock Gear Ratios below:
24/63 - 2.63 Ratio – All M 858 & 600 Mountain Models
27/60 – 2.22 Ratio – All NON-RXC ZR 600 Models, All Riot 600 Models, ONLY Riot 858 Models with 1.75” Paddle Tracks
30/58 – 1.93 Ratio - All ZR 858 Models Including RXC, All RXC 600 Models, All Riot 858 Models Excluding 1.75” Paddle Track
Gear ratio options will be added shortly, in the order notes state your desired ratio and we will contact you shortly for the closest 2 options